Oilfield Glossary

August 12, 2009

1. Sucker Rod - A special steel pumping rod. Several rods screwed together make up the mechanical link from the beam pumping unit on the surface to the sucker rod pump at the bottom of a well. Sucker rods are threaded on each end and manufactured to dimension standards and metal specifications set by the petroleum industry. Lengths are 25 or 30 feet (7.6 or 9.1 meters); diameter varies from 1/2 to 1-1/8 inches (12 to 30 millimeters). There is also a continuous sucker rod
2. Polished Rod - The Top most portion of a string of sucker rods. It is used for lifting fluid by the rod-pumping method. It has a uniform diameter and is smoothly polished to seal pressure effectively in the stuffing box attached to the top of the well.
3. Pony Rod - A sucker rod, shorter than usual, used to make up a sucker rod string of desired length. Pony rods are usually placed just below the polished rod.
4. Beam Pumping Unit - A machine designed specifically for sucker rod pumping. An engine or motor (prime mover) is mounted on the unit to power a rotating crank. The crank moves a horizontal member (walking beam) up and down to produce reciprocating motion. This reciprocating motion operates the pump. Compare pump jack
5. Sucker Rod Pump - The downhole assembly used to lift fluid to the surface by the reciprocating action of the sucker rod string. Basic components are barrel, plunger, valves, and hold-down. Two types of sucker rod pumps are the tubing pump, in which the barrel is attached to the tubing, and the rod, or insert, pump, which is run into the well as a complete unit.
6. Tubing Pump: A sucker rod pump in which the barrel is attached to the tubing.
7. Insert Pump: A sucker rod pump that is run into the well as a complete unit
8. Gas Anchor: A tubular, perforated device attached to the bottom of sucker-rod pump that helps to prevent gas lock. The device works on the principle that gas, being lighter than oil, rises. As well fluids enter the anchor, the gas breaks out of the fluid and exits from the anchor through perforations near the top. The remaining fluids enter the pump through a mosquito bill (a tube with the anchor), which has an opening near the bottom. In this way, all or most of the gas escapes before the fluids enter the pump.
9. Stuffing Box: A device that prevents leakage along a piston, rod, propeller shaft, or other moving part that passes through a hole in a cylinder or vessel. It consists of a box or chamber made by enlarging the hole and a gland containing compressed packing. On a well being artificially lifted by means of a sucker rod pump, the polished rod operates through a stuffing box, preventing escape of oil and diverting it into a side outlet to which is connected the flow line leading to the oil and gas separator or to the field storage tank. For a bottomhole pressure test, the wireline goes through a stuffing box and lubricator, allowing the gauge to be raised and lowered against well pressure. The lubricator provides a pressure-tight grease seal in the stuffing box.
10. Travelling Valve: One of the two valves in a sucker rod pumping system. It moves with the movement of the sucker rod string. On the upstroke, the ball member of the valve is seated, supporting the fluid load. On the downstroke, the ball is unseated, allowing fluid to enter into the production column. Compare standing valve.
11. Standing Valve: A fixed ball-and-seat valve at the lower end of the working barrel of a sucker rod pump. The standing valve and its cage do not move, as does the traveling valve. Compare traveling valve